I'm a bit reluctant to update the BIOS unless its necessary. I have also checked the cables and everything is connected fine. Tried switching ports on my ssd but the problem persists. (Code 10), An I/O adapter hardware error has occurredĪutomatic update does not work. The Plug and Play ID for this device is PCI\VEN_10B9-DEV_5289-SUBSYS_FDB27DF7-REV_01\3-1158Īfter that I also noticed in the Device Manager that Standard the SATA AHCI Controller has a yellow icon and on the Device Status says : It may not have the correct driver installed or may be experiencing a hardware failure. I ran a windows system diagnostics and found an error:Ĭause: A device has a configuration problem that prevents it from starting properly.ĭetails: The device, Standard SATA AHCI Controller, cannot start properly. XP will continue to load files, then stop. Press the F6 key when you see the message Press F6 if you need to install a SATA/RAID driver. I checked my drives and they are healthy. To install via USB FDD, you have to copy and paste the file contents in the folder to a floppy disk drive. It did get into windows eventually, after one or several restarts and ran smoothly from there. My PC, when booting up started prompting some times "Disk read error, press ctrl alt delete to restart" and sometimes got stuck on the windows logo and didn't load. Can't remember what IRST SATA AHCI draivers I was using backthen when I was having Z87/C220 based motherboard (gotta look into my drivers archive) but still have a lot of Asus S56CA and S550CA laptops based on i3 and i5 Ivy Bridge-U CPUs and HM76/C216 chipset/southbridge and these love IRST 12. My motherboard is an Asus Prime A z270, the BIOS version is 0906, not fully updated and I'm running a fully updated windows 10 64bit version. I have a Western Digital Blue 2 TB as secondary storage and a 240 GB Kingston SSDNow V300 where my operating system is.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |